What should be paid attention to daily use of jaw crusher

View previous topic View next topic Go down

What should be paid attention to daily use of jaw crusher

Post  redrose on Thu Nov 14, 2013 11:02 pm

As we all known, with the development of the society,there are more and more kinds of crushing equipment, and the manufacturers are born at the right moment. There are more choices for users more choice ,but at the same time, the corresponding in the choice is increase.If we want to choose the most suitable crusher in numerous manufacturers we have to know our demand at the same time we also need to have a knowledge of different crushers and their advantages and disadvantages.

Thus, there are many kinds of crushers, the commonly used crushers include jaw crusher, impact crusher, composite crusher, cone crusher, roll crusher, shaft impact crusher, etc. Different crushers are used in different industries,for example, jaw crusher is widely used in mining, chemical and other industries.

the jaaw crusher is mainly broke the raw materials a rough break by the use of jaw crusher main raw material for rough break to make preparation for a secondary crushing .

Jaw crusher is suitable for the medium hard raw material, and it is not suitable for crushing the soft hardness raw material. The moisture content of the material shall not be more than 10%, highe moisture content impact the crushing efficiency. then, we should pay attention to the daily use of the jaw crusher.

There are two points should be paid attention to in the use for the brick factory. they are as following:

Firstly, When feeding materials to the jaw crusher, ensure adding materials along the whole width of the feeding port as possible and ensure a uniform feeding, when necessary, can use special feeder to add.

Secondly, Before the materials enter into the crusher,we should sieve out the powder from the material in advance,which is of great significance to the using efficiency of the crusher. Because these powder may seal the slot between the two jaw plate edges,which decrease the effective height of the arris. In that way the materials will be broken only with pressure between the jaw plates.


Of course, maybe my summary is not comprehensive. If you have other supplement, you can comment about my article. We learn from each other, and make progress together. Thank you very much for reading my article. I hope you like it.



redrose

Posts : 43
Join date : 2013-11-14

View user profile

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum